Menu

Antony's Blog

Some helpful locksmith tips and information...

Blog posts : "lock"

Re-Key Tip

rekey-seattle-locksmithOne of the most common jobs a professional locksmith does during his years in the field is re-keying lock cylinders which the purpose of it is to prevent from the old key to work with the lock. Usually these re-key jobs will come from landlord that will have a new tenant moving to a house or an apar…

Read more

DIY Safe

locksmith-reno-padlockI recently got a job from a locksmith company I am working with about a church in the area that were looking to put a locked box just outside the church, so some of the deacons will have an access to the church Master-Key. It seem like the person in charge for some reason didn’t want each one of the…

Read more

Slim Jim Tips


locksmith-spokane-doorDuring the years I moved away from unlocking vehicles and houses with a Slim Jim tool. However, I do have one in my service vehicle just in case. There were few cases in my locksmith career where I had to use a Slim Jim to open a house even thou I acquired different types of tools to work with. Whe…

Read more

Wafer Lock Tip

portland-locksmith-lockAs a professional locksmith technician it seem to me that any other skilled locksmith who is familiar with impressioning will have it easy when dealing with a wafer lock since these types of locks are the most easier ones to fit a first key to by doing impressioning. However, there are some types of…

Read more

Mondeo Lockout Tip

locksmith-boise-ford-lockoutDuring my years as a professional locksmith technician, I rarely ran into European model vehicles made by American automobile manufacturers such as GM and Ford. However, one particular model I recall working on was the Ford Mondeo. When this vehicle first came out in Europe, it was equipped with a l…

Read more

95 Altima Lockout

altima-lockout-portland-locksmithI got a call recently from a locksmith company I've been working with to open a 1995 Nissan Altima. Before I left for the job,  sense I haven't opened that type of vehicle before, I tried reading up on some opening tips in my tool opening manual that I had laying around. However,, the manual only sh…

Read more

Hyundai Key Make

ignition-reno-locksmithWhen I started my locksmith career I noticed that when fitting a first key for a late 80's Hyundai models, the ignition plug can be pulled out of the housing and the wafers read with little to no difficulty at all. Using the back side of a diamond pick to raise and hold the nylon key buzzer activato…

Read more

Nissan Ignition Lock

During my many years in the locksmith business, I received many job calls to replace a C-16 series Datsun and Subaru ignition locks with the X-7 and X-6 key-ways. The locks seem to stop working when the shoulder stop wears away and the key bottoms out past the proper space alignment. One I'm in the …

Read more

Foreign Vehicles Ignition Tip

ignition-spokane-locksmithI that know that many experienced locksmith technicians before me have came up with different ways regarding a  removal of the break-a-way bolts on most foreign car ignitions. However, it seem to me I found a much quicker, simple and effective method to do the procedure  in a way that will allow to …

Read more

Volvo Lock Clip Removal Tip

After many years of experience in the locksmith field I found an easy way for removing the door lock retaining lock clip on a 1985 Volvo, Series 200 without removing the door panel. I'm assuming it might work on other model Volvos as well. On the edge of the door, in line with the lock cylinder, the…

Read more

10 Blog Posts